After I installed the skin, I worked on completing the Bell Crank support rib and finished riveting it to F-706. Also, I worked on some tabs that will support the conduit runs under the seats and baggage compartment.
Tuesday, February 1, 2011
Rear Top Skin
Some odds and ends complete and lots of progress on the rear top skin today. First I finished the second J channel and thought of a pretty good way to keep it centered for drilling. Basically I drilled the first hole centered on the rear most point on the J channel where it would overlap F-708 bulkhead. Then I used those two points to start the clecoing of the rear skin. The first couple pics show this.. Once I was finished clecoing, sure enough, the center lines drawn on the stringers lined up perfectly and will be drilled soon enough.
After I installed the skin, I worked on completing the Bell Crank support rib and finished riveting it to F-706. Also, I worked on some tabs that will support the conduit runs under the seats and baggage compartment.
After I installed the skin, I worked on completing the Bell Crank support rib and finished riveting it to F-706. Also, I worked on some tabs that will support the conduit runs under the seats and baggage compartment.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment