After much turmoil I was able to get the panel attach points in place. Not complete yet but definitely over the hump. This seemed like a straight forward process at the beginning, but turned out to be pretty difficult. In order to get these drilled correctly I had to mount the panel and entire front deck.. Some of the points I could drill straight away, but others I had to mark on the blue tape, remove the panel and forward side rails to get good access to drilling. At this point it is all drilled, I need to rivet the attatch points onto the side rails. For the side attach points my plan is to rivet them first, then attach the nutplates. Excited to be through this part, now the end of the forward section is in site.. Ready for that Finish Kit..