Search This Blog

Friday, January 28, 2011

Firewall Gussets

This piece was a bit tricky.  Trying to make sure that you had enough edge distance all around as well as making sure you space your pre-drilled rivet holes in the gusset appropriately around the end of the tab on the metal firewall angle.  You can see in the bottom picture better what I am talking about.   Also, trying to keep the drill shavings out of the firewall angles where you can't vacuum proved to be a difficult tape/paper job in itself.



Note rivet hole spacing at the
end of the tab on the firewall.

No comments:

Post a Comment

Places we have been in our RV-7 ! (Blue 2013, Yellow 2014, Green 2015, Purple 2016, Red 2017)