Also, I worked on the two center seat ribs a bit and trimmed them where the electrical bushings go through F-705.. I also finished trimming the sections where they open up for the control column. The picture here shows how that works, its pretty cool. In fact I might do this for the next outer two ribs so that I can install and remove the control column all in one piece..
This site shows the years of construction, first flights, and the continued adventures of Chad and Bekah in our RV-7
Wednesday, September 8, 2010
Tail cone riveting and small progress towards center section
Tonight Bekah was out in the garage again hammering away. We made lots of progress on the tail cone, basically finishing all the bottom rivets. Started the lower J-Channel riveting and hopefully tomorrow will finish to the point where we can flip it upright and work standing up for a change..
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment