Search This Blog

Saturday, February 27, 2010

Pushrods and Bell Crank

I was able to finish the pushrods with primer and final pop rivets.   Also, I pre-assembled the Bell Crank.   I had to ream out the brass bushing per the directions so that the bolt would slide through.  Some guys jig the bushing and use a drill press, I just used a hand drill and squeezed the busing in a vise with cardboard around it so not to scuff it.  Worked OK for me.

No comments:

Post a Comment

Places we have been in our RV-7 ! (Blue 2013, Yellow 2014, Green 2015, Purple 2016, Red 2017)